The AMS-Oiler engine pre-oiling system, Model AMK-01, is designed to be mounted directly to the AMSOIL Dual Remote Filtration System models BMK13, BMK15, BMK16, and BMK17 and the AMSOIL Marine Dual Remote Filtration System, BMK18. The AMK-01 kit includes all the necessary fittings and hardware for installation while utilizing the existing hoses of the Duel Remote Filtration System.

Procedure for Mechanical installation

1. Turn ignition to OFF position.
2. Remove the two Allen head plugs (Part No. BP-191 for BMK13, BMK15, BMK16, BMK17 models and Part No. BP- 228 for BMK18) from the filter mount assembly (Part No. BK-209 for BMK13, BMK15, BMK16, BMK17 models and Part No. BU- 194 for BMK18) on the Dual Mount Filtration System. Using a lint free rag, wipe any debris from end of mount. Caution: Behind each Allen head plug is a spring and poppet valve. Insure spring and valve are retained and are reinstalled in same port as originally found.

3. Sample diagram.

   Remove the four (4) o-rings supplied with the AMK-01 out of the bag and use a small amount of motor oil to lubricate the o-rings.
4. Place the thicker cross-section two o-rings (A) onto the two banjo bolts (B) supplied with the kit. (See Figure)
5. Place the two thinner o-rings (C) into the grooves on the inside of the main AMS-Oiler assembly. These will act as a seal between the AMS-Oiler and the By Pass Dual Mount block (See Figure)
6. Place the AMS-Oiler on top of the filter mount assembly. Line up the holes on the AMS-Oiler and the filter mount assembly. Attach the AMS-Oiler using the two supplied banjo bolts. Make sure the two o-rings are still in place between the AMS-Oiler mounting block and the filter mount assembly. Ensure each banjo bolt has one o-ring to seal the outer rim of the bolt. Tighten the banjo bolts with ¼" Allen wrench to 40 - 43 foot-pounds.

Mechanical Assembly is now complete. Refer to the electrical assembly instructions to complete the installation.